Before conversion, program address is 684 but changes to 683 after conversion. I have also noticed a difference in its program address after conversion. Then perform "Compare Program" (CP1H vs CP1H_CP1L_CP1H) and it says "Compare Failed". I only replace PLC to cp1L Another, observation I have is that I convert the original program from CP1H to CP1L and after that, I convert back the converted program to CP1H. By the way, the original PLC(CP1H-X40DT-T) has 3 x CPM1A-20EDR1 and 1 x CPM1A-8ED expansion installed. I was able to upload and download successfully and I didn't receive any errors or warnings. Transfering to my target newPLC does not include TK as it is grayed out and TK checkbox cannot be tick. When it is necessary, install the Sysmac Studio / the CX-One again. After the uninstallation completes and the wizard exits, restart the computer. Start the CXORemover.exe in the unzipped folder. Hi All, I went back to my original PLC and do another backup of PLC program including memory areas(CIO,A,T,C,IR,DR,D,TK,H,W) and successfully transfer it to my target NewPLC. Download OMRON Automation Software Remover and unzip.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |